Tekjunke – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

Tekjunke

Gruppe: Registriert

Beigetreten: 2021/06/12

Eminent Member

	Yes, I’ve completed multiple factory resets and recalibrated... Im Forum User mods - OctoPrint, enclosures, nozzles, ...	Vor 2 years
	Mini+ upgrade mods are causing lots of frustration Im Forum User mods - OctoPrint, enclosures, nozzles, ...	Vor 2 years
	Is there a picture thread? Im Forum General discussion, announcements and releases	Vor 2 years
	Thank you, off to pick some up now. It just so happens that ... Im Forum How do I print this? (Printing help)	Vor 3 years
	I tried a simple first layer calibration on my MK3 with the ... Im Forum How do I print this? (Printing help)	Vor 3 years
	A followup to this, I ended up tearing the printer all the w... Im Forum Hardware, firmware and software help	Vor 3 years
	@turro75 That’s exactly what I was looking for. Not sure how... Im Forum Hardware, firmware and software help	Vor 3 years
	X-axis alignment issue Im Forum Hardware, firmware and software help	Vor 3 years
	Thanks for all the replies an advice. I think I got to the b... Im Forum How do I print this? (Printing help)	Vor 3 years
	Here’s another attempt with -1.200 Im Forum How do I print this? (Printing help)	Vor 3 years
	1.250 looks pretty good and 1.0 barely sticks Im Forum How do I print this? (Printing help)	Vor 3 years
	-1.500 z axis is certainly too low Im Forum How do I print this? (Printing help)	Vor 3 years
	Prusament PETG help Im Forum How do I print this? (Printing help)	Vor 3 years

Seite 2 / 2 Vorherige

Forums-Statistiken

559 Foren

63.1 K Themen

443.8 K Beiträge

21 Online

68.1 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen