Notifications
Clear all
Tekjunke
Tekjunke
Groupe: Enregistré
A(ont) rejoint: 2021/06/12
Eminent Member
2
Yes, I’ve completed multiple factory resets and recalibrated...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 2 years
Mini+ upgrade mods are causing lots of frustration

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 2 years
Is there a picture thread?

Dans le forum General discussion, announcements and releases

il y a 2 years
Thank you, off to pick some up now. It just so happens that ...

Dans le forum How do I print this? (Printing help)

il y a 3 years
I tried a simple first layer calibration on my MK3 with the ...

Dans le forum How do I print this? (Printing help)

il y a 3 years
A followup to this, I ended up tearing the printer all the w...

Dans le forum Hardware, firmware and software help

il y a 3 years
@turro75 That’s exactly what I was looking for. Not sure how...

Dans le forum Hardware, firmware and software help

il y a 3 years
X-axis alignment issue

Dans le forum Hardware, firmware and software help

il y a 3 years
Thanks for all the replies an advice. I think I got to the b...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Here’s another attempt with -1.200

Dans le forum How do I print this? (Printing help)

il y a 3 years
1.250 looks pretty good and 1.0 barely sticks

Dans le forum How do I print this? (Printing help)

il y a 3 years
-1.500 z axis is certainly too low

Dans le forum How do I print this? (Printing help)

il y a 3 years
Prusament PETG help

Dans le forum How do I print this? (Printing help)

il y a 3 years
Page 2 / 2
Partager :