Tekjunke – Aktivita – Prusa3D Forum

Notifications

Clear all

Tekjunke

Skupina: Registrovaný

Přidal se: 2021/06/12

Eminent Member

	Yes, I’ve completed multiple factory resets and recalibrated... In forum User mods - OctoPrint, enclosures, nozzles, ...	před 2 years
	Mini+ upgrade mods are causing lots of frustration In forum User mods - OctoPrint, enclosures, nozzles, ...	před 2 years
	Is there a picture thread? In forum General discussion, announcements and releases	před 2 years
	Thank you, off to pick some up now. It just so happens that ... In forum How do I print this? (Printing help)	před 3 years
	I tried a simple first layer calibration on my MK3 with the ... In forum How do I print this? (Printing help)	před 3 years
	A followup to this, I ended up tearing the printer all the w... In forum Hardware, firmware and software help	před 3 years
	@turro75 That’s exactly what I was looking for. Not sure how... In forum Hardware, firmware and software help	před 3 years
	X-axis alignment issue In forum Hardware, firmware and software help	před 3 years
	Thanks for all the replies an advice. I think I got to the b... In forum How do I print this? (Printing help)	před 3 years
	Here’s another attempt with -1.200 In forum How do I print this? (Printing help)	před 3 years
	1.250 looks pretty good and 1.0 barely sticks In forum How do I print this? (Printing help)	před 3 years
	-1.500 z axis is certainly too low In forum How do I print this? (Printing help)	před 3 years
	Prusament PETG help In forum How do I print this? (Printing help)	před 3 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

559 Fóra

62.8 K Témata

442.2 K Příspěvky

18 Online

67.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed