|
@robert-rmm200 Great reply! I've learned a lot about 3d prin... En el foro Awesome prints (Hall Of Fame) |
hace 4 years |
|
I have been running my MK3 through Octopl for several months... En el foro Hardware, firmware and software help |
hace 5 years |
|
Ok, I should have searched a bit more before posting. The pr... En el foro Assembly and first prints troubleshooting |
hace 6 years |
|
Here is another picture En el foro Assembly and first prints troubleshooting |
hace 6 years |
|
The y axis shift happened twice on the same print, the secon... En el foro Assembly and first prints troubleshooting |
hace 6 years |
|
I just encountered the same problem, after several months of... En el foro Assembly and first prints troubleshooting |
hace 6 years |
|
It was set to MK2. When I change it to MK3, the gcode sets t... En el foro Hardware, firmware and software help |
hace 6 years |
|
Ok, I should have done that first instead of assuming....
T... En el foro Hardware, firmware and software help |
hace 6 years |
|
No, The file is 60, so I assume Prusacontrol sets the gcode ... En el foro Hardware, firmware and software help |
hace 6 years |
|
The temperature in the file is 60 for 1st layer and the rest... En el foro Hardware, firmware and software help |
hace 6 years |
|
The temperature is the same at 55 degrees for all layers. En el foro Hardware, firmware and software help |
hace 6 years |
|
Bed temperature with PrusaControl En el foro Hardware, firmware and software help |
hace 6 years |
