Notifications
Clear all
tanj666
Skupina: Registrovaný
Přidal se: 2018/02/19
Active Member
1
|
Thanks for the reply, Joan. I had already tried all that an... In forum PrusaSlicer |
před 4 years | |
|
How to disable save project settings? In forum PrusaSlicer |
před 4 years | |
|
Been a week, I've tried all sorts. Lower temps - works fine ... In forum Hardware, firmware and software help |
před 5 years | |
|
A very good point indeed. I checked this ages ago, found a ... In forum Hardware, firmware and software help |
před 5 years | |
|
I've read the wonderful post about the heatbreak by the way ... In forum Hardware, firmware and software help |
před 5 years | |
|
i3Mk3S clicking all the time In forum Hardware, firmware and software help |
před 5 years |