Notifications
Clear all
T. Beck
Groupe: Enregistré
A(ont) rejoint: 2022/10/10
Active Member
1
|
Well, I put the filament in the oven at 170°F for 1 hour to ... Dans le forum How do I print this? (Printing help) |
il y a 1 month | |
|
Thanks for the information Auther. As far as the not being ... Dans le forum How do I print this? (Printing help) |
il y a 1 month | |
|
Very Good question. I recently purchased a spool of PA6-CF20... Dans le forum How do I print this? (Printing help) |
il y a 1 month | |
|
Try lubing the bed bearings. Sometimes they run dry and caus... Dans le forum Assembly and first prints troubleshooting |
il y a 3 years | |
|
I had the exact same problem. I found the problem in the Y-... Dans le forum Hardware, firmware and software help |
il y a 3 years |