Prusa3D Forum

Notifications

Clear all

SwimClips

Skupina: PrusaLink-beta

Přidal se: 2021/10/09

Název: Member

	Thank you! I have been thinking about doing an LED mod - I h... In forum Hardware, firmware and software help	před 4 years
	What would cause these horizontal lines? In forum Assembly and first prints troubleshooting	před 4 years
	Filament sensors not coordinating? In forum Hardware, firmware and software help	před 4 years
	Thank you, @neophyl! This is extremely helpful. I will try t... In forum PrusaSlicer	před 4 years
	Thank you!! I have another quick question. In the model show... In forum PrusaSlicer	před 4 years
	I have my Prusa i3 mk3s+ with MMU2s out in my workshop, whil... In forum PrusaSlicer	před 4 years
	Extrusion in space In forum PrusaSlicer	před 4 years
	I was on chat with Prusa technical support today, and Viktor... In forum PrusaSlicer	před 4 years
	Update - I tried 100% "Infill/perimeters overlap" - no impro... In forum PrusaSlicer	před 4 years
	Gap between infill and perimeters In forum PrusaSlicer	před 4 years
	So does this mean I already have the B7 extruder body? In forum Hardware, firmware and software help	před 4 years
	i3 MK3S+ need upgrade to B7 extruder body? In forum Hardware, firmware and software help	před 4 years
	i3 MK3S+ need upgrade to B7 extruder body? In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

585 Fóra

67.9 K Témata

475.9 K Příspěvky

13 Online

75.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed