Notifications
Clear all
STSanford
Skupina: Registrovaný
Přidal se: 2019/01/18
Active Member
1
| Update: I just re-tried the bed leveling and in both PLA nad... | před 5 years | |
| Ok, I did a cold pull, I have attached an image... It think ... | před 5 years | |
| Cannot get 1st layer to stick | před 5 years | |
| I have the MK3S, I don't think I see aPFTE tube, just the to... | před 6 years | |
| Oh man, I'm already down to 25mm, my Ender-3 prints at 45mm ... | před 6 years | |
| Yes. Retractions are off. | před 6 years | |
| Same Result yet again. 37% into the print | před 6 years | |
| Forgot to mention, I also used Slic3r and Simplify 3D to sli... | před 6 years | |
| Difficulty with TPU | před 6 years |