Prusa3D Forum

Notifications

Clear all

STSanford

Groupe: Enregistré

A(ont) rejoint: 2019/01/18

Active Member

	Update: I just re-tried the bed leveling and in both PLA nad... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Ok, I did a cold pull, I have attached an image... It think ... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Cannot get 1st layer to stick Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	I have the MK3S, I don't think I see aPFTE tube, just the to... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Oh man, I'm already down to 25mm, my Ender-3 prints at 45mm ... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Yes. Retractions are off. Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Same Result yet again. 37% into the print Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Forgot to mention, I also used Slic3r and Simplify 3D to sli... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Difficulty with TPU Dans le forum Assembly and first prints troubleshooting	il y a 7 years

Statistiques du forum

585 Forums

68.4 K Sujets

478.7 K Messages

11 En-ligne

76.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé