Notifications
Clear all
SteveS
Skupina: Registrovaný
Přidal se: 2020/07/27
Trusted Member
3
| @jsw good tip, will look at doing that in future. Sorted str... | před 5 years | |
| @jsw thanks for the sage words of advice. I ran another firs... | před 5 years | |
| The MK3S kit was my first foray into 3D printing and after a... | před 5 years | |
| @jsw the printer is an i3 MK3S that was built from a kit a f... | před 5 years | |
| Print quality? | před 5 years | |
| @neophyl You can see the effect when cleaning the PEI sheet ... | před 5 years | |
| @vintagepc I did adjust it but not by that much! about 0.05.... | před 5 years | |
| Textured plate | před 5 years | |
| @bobstro "You may want to calibrate for different filaments ... | před 5 years | |
| @3delight its working fine now. no idea if it was just refit... | před 5 years | |
| update - took the PINDA out completely, popped it back in on... | před 5 years | |
| @andrewld Will check this again when I get more time and ent... | před 5 years | |
| XYZ Calibration | před 5 years |
Stránka 4 / 4
Předchozí