Prusa3D Forum

Notifiche

Cancella tutti

steven.c17

Gruppo: Registrato

Registrato: 2018/02/04

Active Member

	I'm afraid I'm not much help, but I've had similar issues re... Nel forum Hardware, firmware and software help	4 years fa
	I resliced at 0.15 and the first layer went better. Reslice... Nel forum Hardware, firmware and software help	6 years fa
	These kinds of issues can be caused by a lot of different th... Nel forum Hardware, firmware and software help	6 years fa
	Trying to find just regular T8 trapezoidal nuts with the sam... Nel forum Hardware, firmware and software help	7 years fa
	I had the same issue with mine. I found that the trapezoida... Nel forum Hardware, firmware and software help	7 years fa
	I'm not sure it's the same thing, but I noticed something si... Nel forum Hardware, firmware and software help	7 years fa

Statistiche Forum

565 Forum

63.9 K Discussioni

447.9 K Post

19 Online

69.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso