Prusa3D Forum

Notifications

Clear all

steven.c17

Skupina: Registrovaný

Přidal se: 2018/02/04

Active Member

	I'm afraid I'm not much help, but I've had similar issues re... In forum Hardware, firmware and software help	před 4 years
	I resliced at 0.15 and the first layer went better. Reslice... In forum Hardware, firmware and software help	před 6 years
	These kinds of issues can be caused by a lot of different th... In forum Hardware, firmware and software help	před 6 years
	Trying to find just regular T8 trapezoidal nuts with the sam... In forum Hardware, firmware and software help	před 7 years
	I had the same issue with mine. I found that the trapezoida... In forum Hardware, firmware and software help	před 7 years
	I'm not sure it's the same thing, but I noticed something si... In forum Hardware, firmware and software help	před 7 years

Fórum Statistiky

565 Fóra

64.1 K Témata

449.3 K Příspěvky

20 Online

70.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed