|
Just to close this thread out, it turns out the problem was ... In forum Hardware, firmware and software help |
2 years temu |
|
I've realized that the issue only seems to occur when using ... In forum Hardware, firmware and software help |
2 years temu |
|
Ahh, yes I'm working with support still on the issue, but I'... In forum Hardware, firmware and software help |
2 years temu |
|
Yes, menu option was already set to enable the sock. I even ... In forum Hardware, firmware and software help |
2 years temu |
|
Heater test fails with silicon sock on 5.1.0 firmware In forum Hardware, firmware and software help |
2 years temu |
|
I spoke too soon as I am also having issues with prints warp... In forum Hardware, firmware and software help |
2 years temu |
|
I haven't really noticed any difference from 5.0.1 to 5.1.0.... In forum Hardware, firmware and software help |
2 years temu |
|
I have noticed the same, but not to the degree where the fir... In forum Hardware, firmware and software help |
2 years temu |
|
I just updated to the latest firmware 5.1.0 and it appears t... In forum Hardware, firmware and software help |
2 years temu |
|
Steve, thanks for the tips. The fan does in fact spin freely... In forum Hardware, firmware and software help |
2 years temu |
|
Thanks everyone for all the tips and pointers thus far. I ju... In forum Hardware, firmware and software help |
2 years temu |
|
I've run into this same problem on one of my MK4 (the other ... In forum Hardware, firmware and software help |
2 years temu |
|
I have also noticed this problem occasionally using PETG on ... In forum Assembly and first prints troubleshooting |
2 years temu |
|
Support actually had me try that as well, but still without ... In forum Hardware, firmware and software help |
2 years temu |
|
Yep, the buddy board is the control unit in the box on the r... In forum Hardware, firmware and software help |
2 years temu |
|
When you say replace the control board, are you referring to... In forum Hardware, firmware and software help |
2 years temu |
|
Re: I am going to go out on a limb, here and say the printer... In forum Hardware, firmware and software help |
2 years temu |
|
I was on with support for over 3 hours trying multiple thing... In forum Hardware, firmware and software help |
2 years temu |
|
No FW on USB #13604 In forum Hardware, firmware and software help |
2 years temu |
|
Yep understood as there seem to definitely be folks on both ... In forum General discussion, announcements and releases |
2 years temu |
