|
I tried another print today with the model having a base app... Dans le forum How do I print this? (Printing help) |
il y a 12 months |
|
I've noticed the same problem when printing a part about hal... Dans le forum How do I print this? (Printing help) |
il y a 12 months |
|
Just found this thread as I had the same problem on my MK3S+... Dans le forum Assembly and first prints troubleshooting |
il y a 12 months |
|
Just to close this thread out, it turns out the problem was ... Dans le forum Hardware, firmware and software help |
il y a 12 months |
|
I've realized that the issue only seems to occur when using ... Dans le forum Hardware, firmware and software help |
il y a 12 months |
|
Ahh, yes I'm working with support still on the issue, but I'... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Yes, menu option was already set to enable the sock. I even ... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Heater test fails with silicon sock on 5.1.0 firmware Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I spoke too soon as I am also having issues with prints warp... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I haven't really noticed any difference from 5.0.1 to 5.1.0.... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I have noticed the same, but not to the degree where the fir... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I just updated to the latest firmware 5.1.0 and it appears t... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Steve, thanks for the tips. The fan does in fact spin freely... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Thanks everyone for all the tips and pointers thus far. I ju... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I've run into this same problem on one of my MK4 (the other ... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
I have also noticed this problem occasionally using PETG on ... Dans le forum Assembly and first prints troubleshooting |
il y a 1 year |
|
Support actually had me try that as well, but still without ... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Yep, the buddy board is the control unit in the box on the r... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
When you say replace the control board, are you referring to... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Re: I am going to go out on a limb, here and say the printer... Dans le forum Hardware, firmware and software help |
il y a 1 year |
