Aktywność
 
Notifications
Clear all
steve457
steve457
Grupa: Zarejestrowany
Dołączył: 2022/05/11
Trusted Member
3
I tried another print today with the model having a base app...

In forum How do I print this? (Printing help)

12 months temu
I've noticed the same problem when printing a part about hal...

In forum How do I print this? (Printing help)

12 months temu
Just found this thread as I had the same problem on my MK3S+...

In forum Assembly and first prints troubleshooting

12 months temu
Just to close this thread out, it turns out the problem was ...

In forum Hardware, firmware and software help

12 months temu
I've realized that the issue only seems to occur when using ...

In forum Hardware, firmware and software help

12 months temu
Ahh, yes I'm working with support still on the issue, but I'...

In forum Hardware, firmware and software help

1 year temu
Yes, menu option was already set to enable the sock. I even ...

In forum Hardware, firmware and software help

1 year temu
Heater test fails with silicon sock on 5.1.0 firmware

In forum Hardware, firmware and software help

1 year temu
I spoke too soon as I am also having issues with prints warp...

In forum Hardware, firmware and software help

1 year temu
I haven't really noticed any difference from 5.0.1 to 5.1.0....

In forum Hardware, firmware and software help

1 year temu
I have noticed the same, but not to the degree where the fir...

In forum Hardware, firmware and software help

1 year temu
I just updated to the latest firmware 5.1.0 and it appears t...

In forum Hardware, firmware and software help

1 year temu
Steve, thanks for the tips. The fan does in fact spin freely...

In forum Hardware, firmware and software help

1 year temu
Thanks everyone for all the tips and pointers thus far. I ju...

In forum Hardware, firmware and software help

1 year temu
I've run into this same problem on one of my MK4 (the other ...

In forum Hardware, firmware and software help

1 year temu
I have also noticed this problem occasionally using PETG on ...

In forum Assembly and first prints troubleshooting

1 year temu
Support actually had me try that as well, but still without ...

In forum Hardware, firmware and software help

1 year temu
Yep, the buddy board is the control unit in the box on the r...

In forum Hardware, firmware and software help

1 year temu
When you say replace the control board, are you referring to...

In forum Hardware, firmware and software help

1 year temu
Re: I am going to go out on a limb, here and say the printer...

In forum Hardware, firmware and software help

1 year temu
Strona 2 / 4
Share: