|
Thanks for the suggestions. I remembered re-assembling the f... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Cooling fan requires help to start spinning In forum Prusa i3 kit (Archive) |
8 years ago |
|
Thanks Peter that exactly what I needed
Cheers
Steve In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hi Peter
Ok firmware changes sound a bit scary. Any idea wha... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Ok so if I measure resistance with the multimeter across the... In forum Prusa i3 kit (Archive) |
9 years ago |
|
X End Stop Broken? In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hi Peter,
Yes I agree. I replace the tie and it quickly loos... In forum Improvements (Archive) |
9 years ago |
|
Improved x endstop In forum Improvements (Archive) |
9 years ago |
|
Thanks Joan! I guess I should be paying more attention to wh... In forum Others (Archive) |
9 years ago |
|
Nozzle screw thread snapped off in hotend In forum Others (Archive) |
9 years ago |
|
Hi All,
Thanks for the helpful replies 🙂
Yes I ended up tur... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Glass print surface broken after 2 months In forum Prusa i3 kit (Archive) |
9 years ago |
|
Im using Sainsmart HIPS 1.75mm Orange. If anyone has been ab... In forum Print tips (Archive) |
9 years ago |
|
Hi Nigel,
Thanks but from what I read its also used to prin... In forum Print tips (Archive) |
9 years ago |
|
I went back to Tree frog printing as its much less time cons... In forum Print tips (Archive) |
9 years ago |
|
Layer seperation in HIPS print In forum Print tips (Archive) |
9 years ago |
|
Settings > Preheat > Cool down In forum Prusa i3 kit (Archive) |
9 years ago |
|
Peter/Christophe
Ah awesome thanks for the advice! I've onl... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Peter,
Thanks for the pic. Yes thats what I have at the mom... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Thanks Peter.
Er where abouts do I do this? By editing the ... In forum Prusa i3 kit (Archive) |
9 years ago |
