Prusa3D Forum

Notifications

Clear all

steve.a

Grupa: Zarejestrowany

Dołączył: 2016/04/18

Eminent Member

	Thanks for the suggestions. I remembered re-assembling the f... In forum Prusa i3 kit (Archive)	8 years temu
	Cooling fan requires help to start spinning In forum Prusa i3 kit (Archive)	8 years temu
	Thanks Peter that exactly what I needed Cheers Steve In forum Prusa i3 kit (Archive)	8 years temu
	Hi Peter Ok firmware changes sound a bit scary. Any idea wha... In forum Prusa i3 kit (Archive)	8 years temu
	Ok so if I measure resistance with the multimeter across the... In forum Prusa i3 kit (Archive)	8 years temu
	X End Stop Broken? In forum Prusa i3 kit (Archive)	8 years temu
	Hi Peter, Yes I agree. I replace the tie and it quickly loos... In forum Improvements (Archive)	8 years temu
	Improved x endstop In forum Improvements (Archive)	8 years temu
	Thanks Joan! I guess I should be paying more attention to wh... In forum Others (Archive)	8 years temu
	Nozzle screw thread snapped off in hotend In forum Others (Archive)	8 years temu
	Hi All, Thanks for the helpful replies 🙂 Yes I ended up tur... In forum Prusa i3 kit (Archive)	9 years temu
	Glass print surface broken after 2 months In forum Prusa i3 kit (Archive)	9 years temu
	Im using Sainsmart HIPS 1.75mm Orange. If anyone has been ab... In forum Print tips (Archive)	9 years temu
	Hi Nigel, Thanks but from what I read its also used to prin... In forum Print tips (Archive)	9 years temu
	I went back to Tree frog printing as its much less time cons... In forum Print tips (Archive)	9 years temu
	Layer seperation in HIPS print In forum Print tips (Archive)	9 years temu
	Settings > Preheat > Cool down In forum Prusa i3 kit (Archive)	9 years temu
	Peter/Christophe Ah awesome thanks for the advice! I've onl... In forum Prusa i3 kit (Archive)	9 years temu
	Peter, Thanks for the pic. Yes thats what I have at the mom... In forum Prusa i3 kit (Archive)	9 years temu
	Thanks Peter. Er where abouts do I do this? By editing the ... In forum Prusa i3 kit (Archive)	9 years temu

Strona 1 / 2 Następny

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

20 Online

68.9 K Członkowie

Ostatni Post: 0,8 mm Nozzle - failed to print Najnowszy użytkownik:: Kiley Murphy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte