Prusa3D Forum

Notifications

Clear all

Steve

Grupa: Zarejestrowany

Dołączył: 2021/08/14

Active Member

	Ok a massive thanks to everyone - it now works! The key part... In forum PrusaSlicer	4 years temu
	Hi, thanks for trying but that didn't work either. 😪 It neve... In forum PrusaSlicer	4 years temu
	Thank you - I'm getting a bit frustrated now so if you could... In forum PrusaSlicer	4 years temu
	OK, so at each colour change layer instead of selecting an e... In forum PrusaSlicer	4 years temu
	I'm afraid that didn't work... I set the extruder changes in... In forum PrusaSlicer	4 years temu
	Thanks for that. When I first enable the wipe tower it appea... In forum PrusaSlicer	4 years temu
	My printer only has a single extruder, will it still stop an... In forum PrusaSlicer	4 years temu
	Filament Towers In forum PrusaSlicer	4 years temu
	Thanks for all the replies guys, whilst obviously not what I... In forum PrusaSlicer	4 years temu
	The inside is actually more important than the outside as it... In forum PrusaSlicer	4 years temu
	Here's what the print should come out like (this was printed... In forum PrusaSlicer	4 years temu
	This is how the print comes out. This hopefully sho... In forum PrusaSlicer	4 years temu
	Yes without the 3 images I attached being visible there isn'... In forum PrusaSlicer	4 years temu
	Disable Bridging? In forum PrusaSlicer	4 years temu

Statystyki Forum

585 Fora

67.9 K Tematy

476 K Posty

12 Online

75.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte