Steve – Aktivita – Prusa3D Forum

Notifications

Clear all

Steve

Skupina: Registrovaný

Přidal se: 2019/05/02

Estimable Member

	In my case, the object I was printing just barely fit on the... In forum How do I print this? (Printing help)	před 4 years
	Nozzle is seated correctly. It was printing fine until I go... In forum How do I print this? (Printing help)	před 4 years
	The PEI sheet is brand new. I cleaned it with dish soap, dr... In forum How do I print this? (Printing help)	před 4 years
	Mostly white, with a few black spots. The filament is white... In forum How do I print this? (Printing help)	před 4 years
	I'm also getting blobs on the surface, so continuing the pri... In forum How do I print this? (Printing help)	před 4 years
	I needed to set it low so that it would stick to the PEI she... In forum How do I print this? (Printing help)	před 4 years
	RE: What causes this: In forum How do I print this? (Printing help)	před 4 years
	What causes this: In forum How do I print this? (Printing help)	před 4 years
	Printing with Prusament PC blend In forum How do I print this? (Printing help)	před 4 years
	Anybody use 3DXTech petg+CF? In forum How do I print this? (Printing help)	před 4 years
	I found the problem. The Y axis drive toothed pulley on the... In forum Hardware, firmware and software help	před 4 years
	Strange output from a good gcode file In forum Hardware, firmware and software help	před 4 years
	That's ok. I'll just start from the generic. Probably will... In forum How do I print this? (Printing help)	před 4 years
	Thanks. I loaded the generic flex and will start from there... In forum How do I print this? (Printing help)	před 4 years
	The stuff is old Matterhackers TPU. I have printed with it ... In forum How do I print this? (Printing help)	před 4 years
	Anybody have a good Prusaslicer profile for TPU? In forum How do I print this? (Printing help)	před 4 years
	Here are the 3mf and stl files Attachment removed In forum How do I print this? (Printing help)	před 4 years
	How do I get the .3mf file? On my Prusaslicer, the Save Pro... In forum How do I print this? (Printing help)	před 4 years
	If I back off any further, the print won't stick. This setti... In forum How do I print this? (Printing help)	před 4 years
	Problems printing with PETG first layer. In forum How do I print this? (Printing help)	před 4 years

Stránka 11 / 13 Předchozí Další

Fórum Statistiky

595 Fóra

68.9 K Témata

481.7 K Příspěvky

15 Online

77.5 K Uživatelé

Poslední Příspěvek: Thermal Grease Shipping Cost Nový Uživatel: HaydenWizard Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed