Prusa3D Forum

Notifiche

Cancella tutti

stephen.g9

Gruppo: Registrato

Registrato: 2017/09/25

Active Member

	Unfortunately, I think you misinterpreted what I meant by 3x... Nel forum Hardware, firmware and software help	6 years fa
	XYZ Calibration failed. Bed calibration point was not found... Nel forum Hardware, firmware and software help	6 years fa
	Wow...i could have sworn I clicked on the MK2/S Mulit Materi... Nel forum Hardware, firmware and software help	6 years fa
	Not sure what you mean by both sides. The PEI that peeled o... Nel forum Hardware, firmware and software help	6 years fa
	Can PINDA be blocked from reading calibration points? Nel forum Hardware, firmware and software help	6 years fa
	Things have gone from bad to worse. Although I hadn't yet c... Nel forum Prusa i3 kit (Archive)	7 years fa
	Thanks for your suggestion. They measure 14mm without filam... Nel forum Prusa i3 kit (Archive)	7 years fa
	Week old printer with extruding problems Nel forum Prusa i3 kit (Archive)	7 years fa

Statistiche Forum

565 Forum

63.5 K Discussioni

445.6 K Post

18 Online

68.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso