Notifications
Clear all
stephen.g9
Skupina: Registrovaný
Přidal se: 2017/09/25
Active Member
1
|
Unfortunately, I think you misinterpreted what I meant by 3x... In forum Hardware, firmware and software help |
před 7 years | |
|
XYZ Calibration failed. Bed calibration point was not found... In forum Hardware, firmware and software help |
před 7 years | |
|
Wow...i could have sworn I clicked on the MK2/S Mulit Materi... In forum Hardware, firmware and software help |
před 7 years | |
|
Not sure what you mean by both sides. The PEI that peeled o... In forum Hardware, firmware and software help |
před 7 years | |
|
Can PINDA be blocked from reading calibration points? In forum Hardware, firmware and software help |
před 7 years | |
|
Things have gone from bad to worse. Although I hadn't yet c... In forum Prusa i3 kit (Archive) |
před 8 years | |
|
Thanks for your suggestion. They measure 14mm without filam... In forum Prusa i3 kit (Archive) |
před 8 years | |
|
Week old printer with extruding problems In forum Prusa i3 kit (Archive) |
před 8 years |