Prusa3D Forum

Notifications

Clear all

stephen.bannasch

Groupe: Enregistré

A(ont) rejoint: 2021/03/07

Active Member

	fyi: reported a similar issue with bridge infill in an empty... Dans le forum PrusaSlicer	il y a 4 years
	@diem Thanks, I was getting quite confused! Dans le forum How do I print this? (Printing help)	il y a 4 years
	@dan-rogers What in the world are you talking about??? Dans le forum How do I print this? (Printing help)	il y a 4 years
	@diem I'm quite confused about some of the responses to this... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Just finished a print of the alignment tool parts In the C... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@tim-2 Maybe you missed my first post in this thread. The te... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Precision is now better. Changes: 1. I re-did the whole... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Another clue. I just printed the precision cube. This is a v... Dans le forum How do I print this? (Printing help)	il y a 4 years
	MK3S: recent prints are about 0.8 % smaller in X and Y than ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I had lots of small tests to print before I could dig into t... Dans le forum General discussion, announcements and releases	il y a 4 years
	Running firmware 3.9.3-3556 and still using the 16GB card an... Dans le forum General discussion, announcements and releases	il y a 4 years
	Thanks everybody for all the suggestions. Have another two h... Dans le forum General discussion, announcements and releases	il y a 4 years
	Dan, That's a logical suggestion. I should have looked for w... Dans le forum General discussion, announcements and releases	il y a 4 years
	X axis offset 11 mm 60% of the way through 11 hour print ove... Dans le forum General discussion, announcements and releases	il y a 4 years
	Also, if you find an existing issue or make a new one please... Dans le forum PrusaSlicer	il y a 4 years

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

21 En-ligne

68.9 K Membres

Le dernier des messages: Erste Druckversuche mit ASA. Bauteil verzieht sich und läst sich somit von der Platte Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé