Avisos
Vaciar todo
stephen.bannasch
stephen.bannasch
Grupo: Registrado
Registrado: 2021/03/07
Active Member
1
fyi: reported a similar issue with bridge infill in an empty...

En el foro PrusaSlicer

hace 4 years
@diem Thanks, I was getting quite confused!

En el foro How do I print this? (Printing help)

hace 4 years
@dan-rogers What in the world are you talking about???

En el foro How do I print this? (Printing help)

hace 4 years
@diem I'm quite confused about some of the responses to this...

En el foro How do I print this? (Printing help)

hace 4 years
Just finished a print of the alignment tool parts In the C...

En el foro How do I print this? (Printing help)

hace 4 years
@tim-2 Maybe you missed my first post in this thread. The te...

En el foro How do I print this? (Printing help)

hace 4 years
Precision is now better. Changes: 1. I re-did the whole...

En el foro How do I print this? (Printing help)

hace 4 years
Another clue. I just printed the precision cube. This is a v...

En el foro How do I print this? (Printing help)

hace 4 years
MK3S: recent prints are about 0.8 % smaller in X and Y than ...

En el foro How do I print this? (Printing help)

hace 4 years
I had lots of small tests to print before I could dig into t...

En el foro General discussion, announcements and releases

hace 4 years
Running firmware 3.9.3-3556 and still using the 16GB card an...

En el foro General discussion, announcements and releases

hace 4 years
Thanks everybody for all the suggestions. Have another two h...

En el foro General discussion, announcements and releases

hace 4 years
Dan, That's a logical suggestion. I should have looked for w...

En el foro General discussion, announcements and releases

hace 4 years
X axis offset 11 mm 60% of the way through 11 hour print ove...

En el foro General discussion, announcements and releases

hace 4 years
Also, if you find an existing issue or make a new one please...

En el foro PrusaSlicer

hace 4 years
Compartir: