Prusa3D Forum

Notifications

Clear all

stephen.bannasch

Group: Registered

Joined: 2021/03/07

Active Member

	fyi: reported a similar issue with bridge infill in an empty... In forum PrusaSlicer	4 years ago
	@diem Thanks, I was getting quite confused! In forum How do I print this? (Printing help)	4 years ago
	@dan-rogers What in the world are you talking about??? In forum How do I print this? (Printing help)	4 years ago
	@diem I'm quite confused about some of the responses to this... In forum How do I print this? (Printing help)	4 years ago
	Just finished a print of the alignment tool parts In the C... In forum How do I print this? (Printing help)	4 years ago
	@tim-2 Maybe you missed my first post in this thread. The te... In forum How do I print this? (Printing help)	4 years ago
	Precision is now better. Changes: 1. I re-did the whole... In forum How do I print this? (Printing help)	4 years ago
	Another clue. I just printed the precision cube. This is a v... In forum How do I print this? (Printing help)	4 years ago
	MK3S: recent prints are about 0.8 % smaller in X and Y than ... In forum How do I print this? (Printing help)	4 years ago
	I had lots of small tests to print before I could dig into t... In forum General discussion, announcements and releases	4 years ago
	Running firmware 3.9.3-3556 and still using the 16GB card an... In forum General discussion, announcements and releases	4 years ago
	Thanks everybody for all the suggestions. Have another two h... In forum General discussion, announcements and releases	4 years ago
	Dan, That's a logical suggestion. I should have looked for w... In forum General discussion, announcements and releases	4 years ago
	X axis offset 11 mm 60% of the way through 11 hour print ove... In forum General discussion, announcements and releases	4 years ago
	Also, if you find an existing issue or make a new one please... In forum PrusaSlicer	4 years ago

Forum Statistics

565 Forums

63.6 K Topics

446 K Posts

21 Online

68.9 K Members

Latest Post: Thermal Runaway at various times throughout 3 hour print Our newest member: Kiley Murphy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed