Prusa3D Forum

Notifications

Clear all

STEPHANE HAMEL

Skupina: Registrovaný

Přidal se: 2023/10/09

Active Member

	Time remaining to next layer pause and current Z not shown w... In forum Hardware, firmware and software help	před 10 months
	I started getting the File Incomplete message on the printer... In forum Hardware, firmware and software help	před 1 year
	Installing firmware version 3.13.2 for the MK3S+ and 3.3.0 f... In forum Hardware, firmware and software help	před 1 year
	Oh! Didn't realized I had to select a Prusa board... thanks ... In forum Hardware, firmware and software help	před 1 year
	Yes, I tried the serial monitor within Arduino app, but it d... In forum Hardware, firmware and software help	před 1 year
	Just found out that this issue might be solved in future fir... In forum Hardware, firmware and software help	před 1 year
	At the end, I put back version 3.12.2 MK3S+ and 1.0.6 MMU2S ... In forum Hardware, firmware and software help	před 1 year
	I managed to disable the MMU2S in the MK3S+ settings by pres... In forum Hardware, firmware and software help	před 1 year
	Idler cannot home deadlock ! In forum Hardware, firmware and software help	před 1 year

Fórum Statistiky

565 Fóra

63.7 K Témata

446.9 K Příspěvky

22 Online

69.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed