Prusa3D Forum

Notifications

Clear all

stephan.w

Groupe: Enregistré

A(ont) rejoint: 2017/02/15

Active Member

	Fixed! I took the time to connect the multimeter to the sens... Dans le forum Hardware, firmware and software help	il y a 5 years
	MMU2s does not realize it loaded successfully?! Dans le forum Hardware, firmware and software help	il y a 5 years
	Hi, When I got my first i3 I also struggled to get this fig... Dans le forum Others (Archive)	il y a 7 years
	Hi! I went with a compromize of heat transfer and wear resi... Dans le forum Others (Archive)	il y a 7 years
	Hi! Anyone know why the default infill pattern was changed?... Dans le forum Others (Archive)	il y a 7 years
	Hi, Looks good! Since I still have a spare PEI from my MK2 ... Dans le forum Others (Archive)	il y a 7 years
	Looks like we could 3d print some anti-rattling stick that l... Dans le forum Others (Archive)	il y a 7 years
	Hi! I'm so glad I've found this thread! I also have troubl... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Temperature Offset/Calibration possible? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Hi! Definitely no expert - but did you check the hobbed gea... Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

22 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé