Activité
 
Notifications
Clear all
Stefan
Stefan
Groupe: Enregistré
A(ont) rejoint: 2016/06/03
Eminent Member
2
But only on the flatpack from discover store. If i download ...

Dans le forum PrusaSlicer

il y a 2 years
Thanks that worked for me to.

Dans le forum PrusaSlicer

il y a 2 years
Prusaslicer on Steam Deck.

Dans le forum PrusaSlicer

il y a 2 years
but they are all over the model look at his back. ringing /g...

Dans le forum Others (Archive)

il y a 7 years
In not talking about the print lines, I'm talking about the ...

Dans le forum Others (Archive)

il y a 7 years
Vertical lines,

Dans le forum Others (Archive)

il y a 7 years
Here's my 2 cents. I doubt the the Czech users don't speak ...

Dans le forum Improvements (Archive)

il y a 8 years
> I donät know it this is the correct way butI have two w...

Dans le forum Software (Archive)

il y a 8 years
Hi, I donät know it this is the correct way butI have two ...

Dans le forum Software (Archive)

il y a 8 years
can someone explain why I have to double my live z value whe...

Dans le forum Others (Archive)

il y a 8 years
Is slic3r ignoring live z value?

Dans le forum Print tips (Archive)

il y a 8 years
I just installed 3.0.6 and i now have a wierd high pitch noi...

Dans le forum Others (Archive)

il y a 8 years
I ran one of the files I have sliced, which I know have the ...

Dans le forum Others (Archive)

il y a 8 years
Now I have reset again, i checked the difference between noz...

Dans le forum Others (Archive)

il y a 8 years
Now I have reset again, i checked the difference between noz...

Dans le forum Others (Archive)

il y a 8 years
one more thing, now the bedleving fails. "Sensors triggerd t...

Dans le forum Others (Archive)

il y a 8 years
remind me again about the reset precedure, just hold the two...

Dans le forum Others (Archive)

il y a 8 years
one more thing, now the bedleving fails. "Sensors triggerd t...

Dans le forum Others (Archive)

il y a 8 years
So I just upgraded the firmware and ran the x/y calibaration...

Dans le forum Others (Archive)

il y a 8 years
Regarding speed settings, Is'nt 100% Outline Underspeed an...

Dans le forum General discussion, announcements and releases

il y a 8 years
Page 1 / 2
Partager :