Activity
 
Notifications
Clear all
Stefan
Stefan
Group: Registered
Joined: 2016/06/03
Eminent Member
2
But only on the flatpack from discover store. If i download ...

In forum PrusaSlicer

2 years ago
Thanks that worked for me to.

In forum PrusaSlicer

2 years ago
Prusaslicer on Steam Deck.

In forum PrusaSlicer

2 years ago
but they are all over the model look at his back. ringing /g...

In forum Others (Archive)

7 years ago
In not talking about the print lines, I'm talking about the ...

In forum Others (Archive)

7 years ago
Vertical lines,

In forum Others (Archive)

7 years ago
Here's my 2 cents. I doubt the the Czech users don't speak ...

In forum Improvements (Archive)

8 years ago
> I donät know it this is the correct way butI have two w...

In forum Software (Archive)

8 years ago
Hi, I donät know it this is the correct way butI have two ...

In forum Software (Archive)

8 years ago
can someone explain why I have to double my live z value whe...

In forum Others (Archive)

8 years ago
Is slic3r ignoring live z value?

In forum Print tips (Archive)

8 years ago
I just installed 3.0.6 and i now have a wierd high pitch noi...

In forum Others (Archive)

8 years ago
I ran one of the files I have sliced, which I know have the ...

In forum Others (Archive)

8 years ago
Now I have reset again, i checked the difference between noz...

In forum Others (Archive)

8 years ago
Now I have reset again, i checked the difference between noz...

In forum Others (Archive)

8 years ago
one more thing, now the bedleving fails. "Sensors triggerd t...

In forum Others (Archive)

8 years ago
remind me again about the reset precedure, just hold the two...

In forum Others (Archive)

8 years ago
one more thing, now the bedleving fails. "Sensors triggerd t...

In forum Others (Archive)

8 years ago
So I just upgraded the firmware and ran the x/y calibaration...

In forum Others (Archive)

8 years ago
Regarding speed settings, Is'nt 100% Outline Underspeed an...

In forum General discussion, announcements and releases

8 years ago
Page 1 / 2
Share: