Notifications
Clear all
Starlynk
Starlynk
Group: Registered
Joined: 2017/02/10
Trusted Member
3
Thanks! It fixed the M110 and I'm up and running again.

In forum Software (Archive)

7 years ago
Yeah, not sure if you get what I get, but its just Com1 and ...

In forum Others (Archive)

7 years ago
Yup, I have the most recent version. I am guessing that sinc...

In forum Software (Archive)

7 years ago
Same here with problems after updating firmware. I am using...

In forum Software (Archive)

7 years ago
Linear Advance - Slic3r PE

In forum Software (Archive)

7 years ago
I've used the wood, and yes, it does get a bit stringy. Howe...

In forum Awesome prints (Hall Of Fame)

7 years ago
I haven't used eSun PLA+, but it shouldn't be much different...

In forum Others (Archive)

8 years ago
May not be the slicer program. I would check your model and ...

In forum Print tips (Archive)

8 years ago
What temperature are you heating the bed to when using ABS? ...

In forum Others (Archive)

8 years ago
Looking at the images from the tubes and the headphone rest,...

In forum Others (Archive)

8 years ago
Its not uncommon for PEI to sink/rise in areas after a print...

In forum Prusa i3 kit (Archive)

8 years ago
1 full turn of the PINDA is 1mm according to Prusa. I recomm...

In forum Prusa i3 kit (Archive)

8 years ago
Spiral Vase mode only works with a single wall thickness. Lo...

In forum Print tips (Archive)

8 years ago
Looks like your not extracting enough when you lowered the v...

In forum Print tips (Archive)

8 years ago
I recently found out that I have had to use auto cooling wit...

In forum Print tips (Archive)

8 years ago
Not really sure that Slicer PE would be the right place to a...

In forum Software (Archive)

8 years ago
Apparently left side was really not pushed in enough. Yet it...

In forum Prusa i3 kit (Archive)

8 years ago
Just an FYI when you do the calibration for bed leveling. Fi...

In forum Prusa i3 kit (Archive)

8 years ago
Blue paper towels from Costco (Or equivalent) is what I use....

In forum Prusa i3 kit (Archive)

8 years ago
Or 'Continue Purge?' I don't see why it would need to ask a...

In forum Prusa i3 kit (Archive)

8 years ago
Page 2 / 4
Share: