Benachrichtigungen
Alles löschen
Starlynk
Starlynk
Gruppe: Registriert
Beigetreten: 2017/02/10
Trusted Member
3
Thanks! It fixed the M110 and I'm up and running again.

Im Forum Software (Archive)

Vor 7 years
Yeah, not sure if you get what I get, but its just Com1 and ...

Im Forum Others (Archive)

Vor 7 years
Yup, I have the most recent version. I am guessing that sinc...

Im Forum Software (Archive)

Vor 7 years
Same here with problems after updating firmware. I am using...

Im Forum Software (Archive)

Vor 7 years
Linear Advance - Slic3r PE

Im Forum Software (Archive)

Vor 7 years
I've used the wood, and yes, it does get a bit stringy. Howe...

Im Forum Awesome prints (Hall Of Fame)

Vor 7 years
I haven't used eSun PLA+, but it shouldn't be much different...

Im Forum Others (Archive)

Vor 8 years
May not be the slicer program. I would check your model and ...

Im Forum Print tips (Archive)

Vor 8 years
What temperature are you heating the bed to when using ABS? ...

Im Forum Others (Archive)

Vor 8 years
Looking at the images from the tubes and the headphone rest,...

Im Forum Others (Archive)

Vor 8 years
Its not uncommon for PEI to sink/rise in areas after a print...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
1 full turn of the PINDA is 1mm according to Prusa. I recomm...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
Spiral Vase mode only works with a single wall thickness. Lo...

Im Forum Print tips (Archive)

Vor 8 years
Looks like your not extracting enough when you lowered the v...

Im Forum Print tips (Archive)

Vor 8 years
I recently found out that I have had to use auto cooling wit...

Im Forum Print tips (Archive)

Vor 8 years
Not really sure that Slicer PE would be the right place to a...

Im Forum Software (Archive)

Vor 8 years
Apparently left side was really not pushed in enough. Yet it...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
Just an FYI when you do the calibration for bed leveling. Fi...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
Blue paper towels from Costco (Or equivalent) is what I use....

Im Forum Prusa i3 kit (Archive)

Vor 8 years
Or 'Continue Purge?' I don't see why it would need to ask a...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
Seite 2 / 4
Teilen: