|
Sainsmart Tpu, and slighty moded Tpu config from chris wark... Dans le forum Awesome prints (Hall Of Fame) |
il y a 6 years |
|
Juggeling Equipment out of TPU Dans le forum Awesome prints (Hall Of Fame) |
il y a 6 years |
|
did the most things! it works!
thanks for the advises. Dans le forum How do I print this? (Printing help) |
il y a 6 years |
|
Nope no silicon sock...
Here is a better foto of this issue Dans le forum How do I print this? (Printing help) |
il y a 6 years |
|
Petg Problem (dripping,scratch) Dans le forum How do I print this? (Printing help) |
il y a 6 years |
|
Thank you for your patient advice!
Happy making for you.
g... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
hmm sounds good. 🙂
Thx for the advice.
one last question, ... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
The one i have is a Raspberry Pi 1 Modell B+
So there not a ... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Going Octo but wich hardware? Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Thanks Joan!
btw awesome job here! Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Sooo, printer isn´t operating since the blob.
Found the erro... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
I did it!
bud im not sure if my cabels are ok.
Maybe somone ... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
So i came this far.
Over th... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
All fine!, no worris,
nope the cables are full covert in pl... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
I tryed the hot end version, the blob wars to big no chance.... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Mother of Blob (Removement Help) Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Ordered that nozzel looks good. 🙂
Thanks for that advice. :... Dans le forum How do I print this? (Printing help) |
il y a 6 years |
|
Looking for the right set up for carbon Dans le forum How do I print this? (Printing help) |
il y a 6 years |
|
Problem is gone! 😀
Test print looks rly good to me, marg... Dans le forum Assembly and first prints troubleshooting |
il y a 6 years |
|
I rechecked all the screws on the motor´s, nothing lose ore ... Dans le forum Assembly and first prints troubleshooting |
il y a 6 years |
