|
Sainsmart Tpu, and slighty moded Tpu config from chris wark... En el foro Awesome prints (Hall Of Fame) |
hace 6 years |
|
Juggeling Equipment out of TPU En el foro Awesome prints (Hall Of Fame) |
hace 6 years |
|
did the most things! it works!
thanks for the advises. En el foro How do I print this? (Printing help) |
hace 6 years |
|
Nope no silicon sock...
Here is a better foto of this issue En el foro How do I print this? (Printing help) |
hace 6 years |
|
Petg Problem (dripping,scratch) En el foro How do I print this? (Printing help) |
hace 6 years |
|
Thank you for your patient advice!
Happy making for you.
g... En el foro Hardware, firmware and software help |
hace 6 years |
|
hmm sounds good. 🙂
Thx for the advice.
one last question, ... En el foro Hardware, firmware and software help |
hace 6 years |
|
The one i have is a Raspberry Pi 1 Modell B+
So there not a ... En el foro Hardware, firmware and software help |
hace 6 years |
|
Going Octo but wich hardware? En el foro Hardware, firmware and software help |
hace 6 years |
|
Thanks Joan!
btw awesome job here! En el foro Hardware, firmware and software help |
hace 6 years |
|
Sooo, printer isn´t operating since the blob.
Found the erro... En el foro Hardware, firmware and software help |
hace 6 years |
|
I did it!
bud im not sure if my cabels are ok.
Maybe somone ... En el foro Hardware, firmware and software help |
hace 6 years |
|
So i came this far.
Over th... En el foro Hardware, firmware and software help |
hace 6 years |
|
All fine!, no worris,
nope the cables are full covert in pl... En el foro Hardware, firmware and software help |
hace 6 years |
|
I tryed the hot end version, the blob wars to big no chance.... En el foro Hardware, firmware and software help |
hace 6 years |
|
Mother of Blob (Removement Help) En el foro Hardware, firmware and software help |
hace 6 years |
|
Ordered that nozzel looks good. 🙂
Thanks for that advice. :... En el foro How do I print this? (Printing help) |
hace 6 years |
|
Looking for the right set up for carbon En el foro How do I print this? (Printing help) |
hace 6 years |
|
Problem is gone! 😀
Test print looks rly good to me, marg... En el foro Assembly and first prints troubleshooting |
hace 6 years |
|
I rechecked all the screws on the motor´s, nothing lose ore ... En el foro Assembly and first prints troubleshooting |
hace 6 years |
