|
Sainsmart Tpu, and slighty moded Tpu config from chris wark... In forum Awesome prints (Hall Of Fame) |
6 years temu |
|
Juggeling Equipment out of TPU In forum Awesome prints (Hall Of Fame) |
6 years temu |
|
did the most things! it works!
thanks for the advises. In forum How do I print this? (Printing help) |
6 years temu |
|
Nope no silicon sock...
Here is a better foto of this issue In forum How do I print this? (Printing help) |
6 years temu |
|
Petg Problem (dripping,scratch) In forum How do I print this? (Printing help) |
6 years temu |
|
Thank you for your patient advice!
Happy making for you.
g... In forum Hardware, firmware and software help |
6 years temu |
|
hmm sounds good. 🙂
Thx for the advice.
one last question, ... In forum Hardware, firmware and software help |
6 years temu |
|
The one i have is a Raspberry Pi 1 Modell B+
So there not a ... In forum Hardware, firmware and software help |
6 years temu |
|
Going Octo but wich hardware? In forum Hardware, firmware and software help |
6 years temu |
|
Thanks Joan!
btw awesome job here! In forum Hardware, firmware and software help |
6 years temu |
|
Sooo, printer isn´t operating since the blob.
Found the erro... In forum Hardware, firmware and software help |
6 years temu |
|
I did it!
bud im not sure if my cabels are ok.
Maybe somone ... In forum Hardware, firmware and software help |
6 years temu |
|
So i came this far.
Over th... In forum Hardware, firmware and software help |
6 years temu |
|
All fine!, no worris,
nope the cables are full covert in pl... In forum Hardware, firmware and software help |
6 years temu |
|
I tryed the hot end version, the blob wars to big no chance.... In forum Hardware, firmware and software help |
6 years temu |
|
Mother of Blob (Removement Help) In forum Hardware, firmware and software help |
6 years temu |
|
Ordered that nozzel looks good. 🙂
Thanks for that advice. :... In forum How do I print this? (Printing help) |
6 years temu |
|
Looking for the right set up for carbon In forum How do I print this? (Printing help) |
6 years temu |
|
Problem is gone! 😀
Test print looks rly good to me, marg... In forum Assembly and first prints troubleshooting |
6 years temu |
|
I rechecked all the screws on the motor´s, nothing lose ore ... In forum Assembly and first prints troubleshooting |
6 years temu |
