Notifications
Clear all
spiff72
spiff72
Skupina: Registrovaný
Přidal se: 2019/07/15
Trusted Member
3
I know this is an older thread, but I just noticed (or at le...

In forum Hardware, firmware and software help

před 10 months
Adding a bit more detail... Attaching a screen shot of the e...

In forum PrusaSlicer

před 3 years
Installer states that some portion of the update failed (2.4...

In forum PrusaSlicer

před 3 years
The issue I had with the Y-axis was not vertical slop - the ...

In forum Hardware, firmware and software help

před 3 years
I forgot to post an update here after my last print... The s...

In forum Hardware, firmware and software help

před 3 years
I will try that after this test print is done in a few hours...

In forum Hardware, firmware and software help

před 3 years
I am not sure this is the same "banding" issue I see when I ...

In forum Hardware, firmware and software help

před 3 years
I will do some googling on that - thanks!

In forum Hardware, firmware and software help

před 3 years
I just printed the BELT GT2 tension gauge and tightened the ...

In forum Hardware, firmware and software help

před 3 years
Layer Shifting on tall skinny part

In forum Hardware, firmware and software help

před 3 years
@paul-arden Thanks - mine is the black one as well.

In forum Hardware, firmware and software help

před 4 years
@paul-arden Did you have the silver or black PSU?

In forum Hardware, firmware and software help

před 4 years
I do have it plugged into a UPS, so I might have to try disc...

In forum Hardware, firmware and software help

před 4 years
I know this is an old thread, but I just finished a 30+ hour...

In forum Hardware, firmware and software help

před 4 years
Odd pause after filament runout - LCD cycles through many me...

In forum Hardware, firmware and software help

před 4 years
@lize Interesting - that is something I will have to dig int...

In forum PrusaSlicer

před 4 years
@lize Thanks for the response! Unfortunately, I just tried ...

In forum PrusaSlicer

před 4 years
Customization of the Gcode file name - question about placeh...

In forum PrusaSlicer

před 4 years
@neophyl OK - thanks. Maybe I will post an issue on Github ...

In forum PrusaSlicer

před 4 years
One more point... I am using the desktop shortcut to launch ...

In forum PrusaSlicer

před 4 years
Stránka 1 / 5
Share: