Prusa3D Forum

Notifications

Clear all

spdrp

Grupa: Zarejestrowany

Dołączył: 2020/06/02

Active Member

	Still with the broken display, I printed the circles and the... In forum Hardware, firmware and software help	4 years temu
	@michael-19 Tomorrow I will try the circles and the built in... In forum Hardware, firmware and software help	4 years temu
	I put back the old, broken print display unit, did a calibra... In forum Hardware, firmware and software help	4 years temu
	(not so) close enough. before the display replacement, after... In forum Hardware, firmware and software help	4 years temu
	RE: Faulty prints after changing the print display In forum Hardware, firmware and software help	4 years temu
	Faulty prints after changing the print display In forum Hardware, firmware and software help	4 years temu
	For me, this was because an unsigned driver. You can check i... In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

19 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte