Prusa3D Forum

Notifiche

Cancella tutti

spdrp

Gruppo: Registrato

Registrato: 2020/06/02

Active Member

	Still with the broken display, I printed the circles and the... Nel forum Hardware, firmware and software help	4 years fa
	@michael-19 Tomorrow I will try the circles and the built in... Nel forum Hardware, firmware and software help	4 years fa
	I put back the old, broken print display unit, did a calibra... Nel forum Hardware, firmware and software help	4 years fa
	(not so) close enough. before the display replacement, after... Nel forum Hardware, firmware and software help	4 years fa
	RE: Faulty prints after changing the print display Nel forum Hardware, firmware and software help	4 years fa
	Faulty prints after changing the print display Nel forum Hardware, firmware and software help	4 years fa
	For me, this was because an unsigned driver. You can check i... Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

559 Forum

62.9 K Discussioni

442.9 K Post

19 Online

67.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso