Prusa3D Forum

Notifications

Clear all

Soynuts

Grupa: Zarejestrowany

Dołączył: 2016/07/21

Active Member

	Went ahead and just soldered the wires to the back of the ra... In forum Others (Archive)	7 years temu
	Melted power connector In forum Others (Archive)	7 years temu
	Yes, you can safely cut and solder the wires. I've done it ... In forum Others (Archive)	7 years temu
	After completely disconnecting the rambo and removing it, it... In forum Others (Archive)	7 years temu
	Just checked the 15A fuse with a multimeter and it shows it ... In forum Others (Archive)	7 years temu
	Heated Bed Dead? In forum Others (Archive)	7 years temu
	I had a similar issue with constant random thermal runaway. ... In forum Others (Archive)	8 years temu
	I've run into the same problem the past week. I couldn't se... In forum Prusa i3 kit (Archive)	8 years temu
	Your probe looks to be far too low. It should be up a bit h... In forum Prusa i3 kit (Archive)	8 years temu
	I've been printing with ABS for the past 4 years so I'm quit... In forum Prusa i3 kit (Archive)	8 years temu
	PEI bubbles In forum Prusa i3 kit (Archive)	8 years temu

Statystyki Forum

567 Fora

64.7 K Tematy

453.1 K Posty

23 Online

71.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte