Prusa3D Forum

Notifications

Clear all

Soynuts

Skupina: Registrovaný

Přidal se: 2016/07/21

Active Member

	Went ahead and just soldered the wires to the back of the ra... In forum Others (Archive)	před 7 years
	Melted power connector In forum Others (Archive)	před 7 years
	Yes, you can safely cut and solder the wires. I've done it ... In forum Others (Archive)	před 7 years
	After completely disconnecting the rambo and removing it, it... In forum Others (Archive)	před 7 years
	Just checked the 15A fuse with a multimeter and it shows it ... In forum Others (Archive)	před 7 years
	Heated Bed Dead? In forum Others (Archive)	před 7 years
	I had a similar issue with constant random thermal runaway. ... In forum Others (Archive)	před 8 years
	I've run into the same problem the past week. I couldn't se... In forum Prusa i3 kit (Archive)	před 8 years
	Your probe looks to be far too low. It should be up a bit h... In forum Prusa i3 kit (Archive)	před 8 years
	I've been printing with ABS for the past 4 years so I'm quit... In forum Prusa i3 kit (Archive)	před 8 years
	PEI bubbles In forum Prusa i3 kit (Archive)	před 8 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.3 K Příspěvky

19 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed