Notifications
Clear all
Soynuts
Group: Registered
Joined: 2016/07/21
Active Member
1
Went ahead and just soldered the wires to the back of the ra... In forum Others (Archive) |
7 years ago | |
Melted power connector In forum Others (Archive) |
7 years ago | |
Yes, you can safely cut and solder the wires. I've done it ... In forum Others (Archive) |
7 years ago | |
After completely disconnecting the rambo and removing it, it... In forum Others (Archive) |
7 years ago | |
Just checked the 15A fuse with a multimeter and it shows it ... In forum Others (Archive) |
7 years ago | |
Heated Bed Dead? In forum Others (Archive) |
7 years ago | |
I had a similar issue with constant random thermal runaway. ... In forum Others (Archive) |
8 years ago | |
I've run into the same problem the past week. I couldn't se... In forum Prusa i3 kit (Archive) |
8 years ago | |
Your probe looks to be far too low. It should be up a bit h... In forum Prusa i3 kit (Archive) |
8 years ago | |
I've been printing with ABS for the past 4 years so I'm quit... In forum Prusa i3 kit (Archive) |
8 years ago | |
PEI bubbles In forum Prusa i3 kit (Archive) |
8 years ago |