Prusa3D Forum

Notifications

Clear all

Solidev

Skupina: Registrovaný

Přidal se: 2022/03/18

Active Member

	The issue was due to vibration from another printer. I moved... In forum Assembly and first prints troubleshooting	před 2 years
	I'm expecting the same results I see on my other printers... In forum Assembly and first prints troubleshooting	před 2 years
	Fist layer not continuous lines. Dotted. In forum Assembly and first prints troubleshooting	před 2 years
	Poor Surface Finish In forum Assembly and first prints troubleshooting	před 2 years
	I took the photo specifically for this post and the more I l... In forum Assembly and first prints troubleshooting	před 2 years
	Hey Michael, Z offset is definitely way too high. Lower unti... In forum Assembly and first prints troubleshooting	před 2 years
	Poor Surface Finish In forum Assembly and first prints troubleshooting	před 2 years
	Rotated part 90 degrees so the mounts are on the sides as op... In forum Assembly and first prints troubleshooting	před 2 years
	RE: Intermittent Printing Issues In forum Assembly and first prints troubleshooting	před 2 years
	Printer #2 now acting up. Front side. Overture Matte Black P... In forum Assembly and first prints troubleshooting	před 2 years
	I will try that. I did try increasing the print temperature ... In forum Assembly and first prints troubleshooting	před 2 years
	I have the same issue with plain PLA, but again, only on thi... In forum Assembly and first prints troubleshooting	před 2 years
	Intermittent Printing Issues In forum Assembly and first prints troubleshooting	před 2 years
	Looking for a way to do the same thing. Still no solution fo... In forum Hardware, firmware and software help	před 3 years
	Try raising your zero offset. Mine looks much better now. In forum Assembly and first prints troubleshooting	před 3 years
	Same issue here. I have two MK3S one has a nice matte finish... In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

565 Fóra

63.9 K Témata

447.7 K Příspěvky

19 Online

69.5 K Uživatelé

Poslední Příspěvek: Xl extruder stops Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed