Prusa3D Forum

Notifiche

Cancella tutti

Smifff

Gruppo: Registrato

Registrato: 2015/08/06

Eminent Member

	I have had my new MK3 running for a week and it has been doi... Nel forum Hardware, firmware and software help	6 years fa
	I failed with temperature adjustments with Prusament but got... Nel forum How do I print this? (Printing help)	6 years fa
	Mk2 print failures with Nel forum How do I print this? (Printing help)	6 years fa
	After re-soldering the heat bed connections and doing all I ... Nel forum Hardware, firmware and software help	8 years fa
	I just looked at the miniRambo schematics at and see that t... Nel forum Hardware, firmware and software help	8 years fa
	To clarify 3) I applied 12v from a Liion battery directly to... Nel forum Hardware, firmware and software help	8 years fa
	Bed not heating after years of sterling service Nel forum Hardware, firmware and software help	8 years fa
	The new roll arrived when I was on the road (hence the delay... Nel forum Others (Archive)	9 years fa
	Update> Still no joy so I shared the details with Taulman... Nel forum Others (Archive)	9 years fa
	Update: I have tried increasing temperature and playing with... Nel forum Others (Archive)	9 years fa
	Taulman Bridge feed problem (nylon) Nel forum Others (Archive)	9 years fa
	All the things I tried and it appears that the extra 5 deg C... Nel forum Others (Archive)	9 years fa
	Thanks for the suggestions. I switched to IPA early on and ... Nel forum Others (Archive)	9 years fa
	I was hoping to live without glue stick but I will if I have... Nel forum Others (Archive)	9 years fa
	PLA lifting problem. Nel forum Others (Archive)	9 years fa
	I just upgraded to MK2 and have the same problem. When Luc ... Nel forum Others (Archive)	10 years fa
	Merci. Nel forum Others (Archive)	10 years fa
	Update: Apart from the print fan issues through not having a... Nel forum Others (Archive)	10 years fa
	Stuck! Upgrade from i3 MK1 3mm version Nel forum Others (Archive)	10 years fa
	Thanks. Great information. I may end up taking the path you ... Nel forum Others (Archive)	10 years fa

Pagina 1 / 2 Avanti

Statistiche Forum

595 Forum

70.6 K Discussioni

494.2 K Post

11 Online

82 K Utenti

Post recenti: Filament always gets stuck in Nextruder on retraction—but only filament 5 Ultimo utente registrato: MiniCity Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso