Prusa3D Forum

Notifications

Clear all

Skint007

Skupina: Registrovaný

Přidal se: 2018/12/08

Active Member

	Printer is extremely loud during certain moves? In forum Hardware, firmware and software help	před 5 years
	Wash the sheet with dish soap (plain dawn or palmolive ) and... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks for the tip guys, you weren't kidding about to low lo... In forum Assembly and first prints troubleshooting	před 6 years
	Can't figure out what the problem is with my first layers (P... In forum Assembly and first prints troubleshooting	před 6 years
	So I fixed the issue of the one side not going up after a ce... In forum Assembly and first prints troubleshooting	před 6 years
	you could be a little bit to far off the build plate but aso... In forum Assembly and first prints troubleshooting	před 6 years
	Z axis can't go up all the way (With video) In forum Assembly and first prints troubleshooting	před 6 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

19 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed