Čeština
Fóra
Uživatelé
sjwill04
Aktivita
 
Notifications
Clear all
sjwill04
sjwill04
Skupina: Registrovaný
Přidal se: 2022/01/03
Active Member
1
Profile Aktivita
What #&! happened?

In forum Hardware, firmware and software help

 před 2 years
Thank you all again! With your feedback I was able to do it....

In forum How do I print this? (Printing help)

 před 3 years
This is a great suggestion. I'll order some PETG and give th...

In forum How do I print this? (Printing help)

 před 3 years
Thank you for your contribution to this thread - I've heard ...

In forum How do I print this? (Printing help)

 před 3 years
This technique got the print head to position where I want i...

In forum How do I print this? (Printing help)

 před 3 years
Print on top of microscope slide

In forum How do I print this? (Printing help)

 před 3 years
Update: I received a replacement z-motor with the thread. Th...

In forum Assembly and first prints troubleshooting

 před 3 years
I've read your post and it closely mimics my experience. If ...

In forum Assembly and first prints troubleshooting

 před 3 years
^^^ Chris is absolutely correct. Look at my post and videos ...

In forum Assembly and first prints troubleshooting

 před 3 years
I have had a similar issue with my Mini+. (You can find a re...

In forum Assembly and first prints troubleshooting

 před 3 years
Update: Prusa supplort chat said that they were going to rep...

In forum Assembly and first prints troubleshooting

 před 3 years
First, I want to say that Prusa has great customer service. ...

In forum Assembly and first prints troubleshooting

 před 3 years
BogdahH is absolutely correct here with regards to assembly....

In forum Assembly and first prints troubleshooting

 před 3 years
In case the video didn't embed in my above post, here is a Y...

In forum Assembly and first prints troubleshooting

 před 3 years
Dislodge and Z-motor issues

In forum Assembly and first prints troubleshooting

 před 3 years
Share: