Prusa3D Forum

Notifications

Clear all

Sebastian

Groupe: Enregistré

A(ont) rejoint: 2020/03/15

Active Member

	Yes. Power on or off makes no difference. Disabling steppers... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	The lead screw is not lubricated. Sorry if I have been uncle... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Stuck as in I should be able to move the thread with my hand... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Z axis not moving Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Didn't know about that. But it's just a manual process and n... Dans le forum Hardware, firmware and software help	il y a 5 years
	I would be interested in an updated profile too. The old one... Dans le forum Hardware, firmware and software help	il y a 5 years
	Maybe stupid question: On which USB port do I connect my Ras... Dans le forum General discussion, announcements and releases	il y a 5 years
	Since I didn't want to keep the printer running idle for so ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Since the filament wasn't loaded completely I could also jus... Dans le forum Hardware, firmware and software help	il y a 6 years
	Change filament in the middle of a print Dans le forum Hardware, firmware and software help	il y a 6 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.7 K Messages

11 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé