Prusa3D Forum

Notifications

Clear all

Sebastian

Skupina: Registrovaný

Přidal se: 2020/03/15

Active Member

	Yes. Power on or off makes no difference. Disabling steppers... In forum Assembly and first prints troubleshooting	před 2 years
	The lead screw is not lubricated. Sorry if I have been uncle... In forum Assembly and first prints troubleshooting	před 2 years
	Stuck as in I should be able to move the thread with my hand... In forum Assembly and first prints troubleshooting	před 2 years
	Z axis not moving In forum Assembly and first prints troubleshooting	před 2 years
	Didn't know about that. But it's just a manual process and n... In forum Hardware, firmware and software help	před 4 years
	I would be interested in an updated profile too. The old one... In forum Hardware, firmware and software help	před 4 years
	Maybe stupid question: On which USB port do I connect my Ras... In forum General discussion, announcements and releases	před 5 years
	Since I didn't want to keep the printer running idle for so ... In forum Hardware, firmware and software help	před 5 years
	Since the filament wasn't loaded completely I could also jus... In forum Hardware, firmware and software help	před 5 years
	Change filament in the middle of a print In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

559 Fóra

63.1 K Témata

443.9 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed