Notifications
Clear all
screw_ball69
screw_ball69
Skupina: Registrovaný
Přidal se: 2018/03/06
Eminent Member
2
Thanks

In forum General discussion, announcements and releases

před 2 years
You didnt read the thread did you?

In forum General discussion, announcements and releases

před 2 years
The title of this post literally says MK3...and that one is ...

In forum General discussion, announcements and releases

před 2 years
The giant not compatible with part Edit it was in resp...

In forum General discussion, announcements and releases

před 2 years
You didnt think I had already checked?  Capture.PNG

In forum General discussion, announcements and releases

před 2 years
I mean I dont need to be in the room I mostly just wanna mak...

In forum General discussion, announcements and releases

před 2 years
I've ordered one off etsy for the time being I was going to ...

In forum General discussion, announcements and releases

před 2 years
MK3 replacment fan shroud

In forum General discussion, announcements and releases

před 2 years
I think I'll just wait

In forum Hardware, firmware and software help

před 2 years
Totally, just wasnt sure if it was out of date info that had...

In forum Hardware, firmware and software help

před 2 years
Revo 6 and firmware

In forum Hardware, firmware and software help

před 2 years
Oooh, thanks for the tip on the Revo. I hadnt noticed that i...

In forum Hardware, firmware and software help

před 3 years
Wires to heat block severed, what are my options?

In forum Hardware, firmware and software help

před 3 years
Are you printing somewhere cold? I know if mine drops below ...

In forum Hardware, firmware and software help

před 3 years
I'll give it a shot. curious how do you do 7x7 mesh levelin...

In forum Hardware, firmware and software help

před 6 years
Ah good to know , I generally try not to touch the bed itsel...

In forum Hardware, firmware and software help

před 6 years
I understand that overuse of acetone will make PEI britle wh...

In forum Hardware, firmware and software help

před 6 years
Here is print 1 vs print 2. No settings changed and cleaned ...

In forum Hardware, firmware and software help

před 6 years
Yes I am cleaning between prints with 99% alcohol and occasi...

In forum Hardware, firmware and software help

před 6 years
The calibration squares are the ones from here: The same G...

In forum Hardware, firmware and software help

před 6 years
Stránka 1 / 2
Share: