Notifications
Clear all
SciPrint
SciPrint
Group: Registered
Joined: 2026/01/06
Eminent Member
2
Yeah sounds like a good solution. I don't think there is any...

In forum User mods

4 weeks ago
Yes siraya has some nice filaments and I bought some of that...

In forum User mods

4 weeks ago
I did a dry fit and it did have enough space. Also for most ...

In forum User mods

4 weeks ago
No that is the polis copper block which I have, but I was co...

In forum User mods

4 weeks ago
Hey good job mate. Why didnt you try the copperhead block?

In forum User mods

4 weeks ago
Show us something you printed.

In forum User mods - OctoPrint, Enclosure, Nozzles, ...

2 months ago
Can reprint stuff and get cpap cooling.

In forum User mods

2 months ago
Consumer and professional plastic distinctions is abit arbit...

In forum User mods

2 months ago
It can be as simple as wanting to print a part for a bicycle...

In forum User mods

2 months ago
PPA-CF is pretty high performance already and it needs highe...

In forum User mods

2 months ago
Thats what it looks like from here too: Annoyingly the git...

In forum User mods

2 months ago
Hopefully it won't take too long. I think alot of these sett...

In forum User mods

3 months ago
When do you think that might be? I see in master they alread...

In forum User mods

3 months ago
If the TDS is to be believed the mechanical properties are p...

In forum User mods

3 months ago
Haha sorry about that! Its MetaCollins as per the thread her...

In forum User mods

3 months ago
Yes I am wondering if I should wait for the new firmware rel...

In forum User mods

3 months ago
Won't the diamond fall out at this temp? I think they are ra...

In forum User mods - OctoPrint, Enclosure, Nozzles, ...

3 months ago
Hi Cedric. Great work. Are you using MeltaCollins firmware?

In forum User mods

3 months ago
It looks like the pt1000 configuration already exists in the...

In forum General discussion, announcements and releases

3 months ago
Thermal Model

In forum Hardware, firmware and software help

3 months ago
Page 1 / 2
Share: