|
Uhhh, wait a minute. Sorry for capturing the thread (if so).... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
After Unsing Slicer 2.6.1 -> New Firmware demand. But for MM... Dans le forum Hardware, firmware and software help |
il y a 1 year |
|
Yep.
You can choose between 3x3 and 7x7.
Steve Dans le forum General discussion, announcements and releases |
il y a 6 years |
|
It is a setting in Slic3rPE. Take a look at Printer Settings... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Standard PLA flow rate at 95 % ? Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Well, in my case it looks like the problem was a defective f... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
I changed the filament sensor, and I succeded.
The printer w... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
So, I switched back to Rev. 3.1.3. The last Version, `known... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
Ah, O.K. Stahlfabrik,
So If I understood the system, the on... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
What was the firmware number before the last one Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
Another Update of the update
Switched the Filament sensor b... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
Err... dear Joan,
first, I was quiet happy with the solutio... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
I just had the same problem with red colored PLA(+) filament... Dans le forum Hardware, firmware and software help |
il y a 7 years |
|
It throws this error message if the file name contains speci... Dans le forum Others (Archive) |
il y a 7 years |
