|
Uhhh, wait a minute. Sorry for capturing the thread (if so).... In forum Hardware, firmware and software help |
1 year ago |
|
After Unsing Slicer 2.6.1 -> New Firmware demand. But for MM... In forum Hardware, firmware and software help |
1 year ago |
|
Yep.
You can choose between 3x3 and 7x7.
Steve In forum General discussion, announcements and releases |
6 years ago |
|
It is a setting in Slic3rPE. Take a look at Printer Settings... In forum Hardware, firmware and software help |
6 years ago |
|
Standard PLA flow rate at 95 % ? In forum Hardware, firmware and software help |
6 years ago |
|
Well, in my case it looks like the problem was a defective f... In forum Hardware, firmware and software help |
7 years ago |
|
I changed the filament sensor, and I succeded.
The printer w... In forum Hardware, firmware and software help |
7 years ago |
|
So, I switched back to Rev. 3.1.3. The last Version, `known... In forum Hardware, firmware and software help |
7 years ago |
|
Ah, O.K. Stahlfabrik,
So If I understood the system, the on... In forum Hardware, firmware and software help |
7 years ago |
|
What was the firmware number before the last one In forum Hardware, firmware and software help |
7 years ago |
|
Another Update of the update
Switched the Filament sensor b... In forum Hardware, firmware and software help |
7 years ago |
|
Err... dear Joan,
first, I was quiet happy with the solutio... In forum Hardware, firmware and software help |
7 years ago |
|
I just had the same problem with red colored PLA(+) filament... In forum Hardware, firmware and software help |
7 years ago |
|
It throws this error message if the file name contains speci... In forum Others (Archive) |
7 years ago |
