Prusa3D Forum

Notifications

Clear all

samuel

Grupa: Zarejestrowany

Dołączył: 2020/11/16

New Member

	An update on this issue. It turned out that the problem was ... In forum Hardware, firmware and software help	5 years temu
	Ok, my assumption would be bad gcode then. I have never prin... In forum Hardware, firmware and software help	5 years temu
	Printer starts mid-bed, not from bottom left In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

585 Fora

68.1 K Tematy

477.2 K Posty

10 Online

75.8 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte